• Monday - Saturday 9 AM - 5PM

50’ x 24’ x 5’ Sectional/Truckable Barge & Dredge

Listing Details
Category Marine Construction
Sub-Category Push Boats
Manufacturer N/A
Model N/A
Condition New
Year N/A
Hours N/A
Serial Number N/A
Location United States, Midwest
Description

This barge is configured with 2 sections that are 50’ x 12’ x 5’. Both sections are raked on the bow with a 12” head log that is 1/2” thick plate. Each section has a solid 1/4” steel bulkhead making each section 2 compartments. There is 1-18” flush mounted access hatch per compartment in each section. All plate is A-36 1/4” steel. Framing is a 3” x 3” x 1/4” angle transverse truss frame spaced every 18” apart. The Connector Angles are 6” x 4” x 5/8” and are full length of barge. The connector holes are 1.75” diameter, spaced 48” apart, and the pins are 1.5” diameter with a pointed end and a single 3/8” square cap top.

Each section is air-tested, sand blasted, and coated with a 2-part salt resistant marine epoxy. One section per loaded trailer. Each section weighs approx: 30,000 lbs. each. Empty Draft is at 10.5” and can carry 80-100 tons with a 12” free board. Maximum deck load depends on size of actual load. It takes 69,000 lbs. to push this barge down 12” in the water.

Ask about other sizes!

Similar Listings